Santa Cruz and Juliana Shock and Pivot Bolt Installation

      • Remove air out of shock
      • Remove front shock bolt
      • Move rear swing arm to access the rear shock bolt freely without damaging the frame
      • Remove rear shock bolt
      • Apply anti seize to threads of all bolts and waterproof grease to the shank (smooth portion) of the two shock bolts
      • Install top shock bolt first to torque spec found on below
      • Install rear shock bolt to correct torque setting
      • Remove the 3 pivot bolts and washers
      • Apply anti seize to theads and to the contact area of the washer supplied and the cone washer supplied with the bike, having anti-seize between aluminum and titanium is important
      • Install bolts to the torque spec found in the links above
      • Recheck that all bolts are tight.
      • Enjoy the ride!
Older Post
Newer Post

Leave a comment

Please note, comments must be approved before they are published

Close (esc)

Popup

Use this popup to embed a mailing list sign up form. Alternatively use it as a simple call to action with a link to a product or a page.

Age verification

By clicking enter you are verifying that you are old enough to consume alcohol.

Search

Shopping Cart

Your cart is currently empty.
Shop now